Some scratches cannot be removed, even with the use of our special polish. In these instances, the QUIXX Paint Repair Pen can be used to prevent the damage from getting worse. Very deep scratches and scrapes that can reach the primer, as well as stone chips in the paint can all be treated with the Pen. The special pen tip works in unison with the genuine clear lacquer inside the pen, to fill deep damaged areas, thus preventing the threat of corrosion, oxidation, or paint blistering.
Our step-by-step repair instructions will explain how to treat deep scratches, even those reaching down to the primer, with the QUIXX Paint Repair Pen and, at the same time, prevent the threat of corrosion and oxidation.
Click through the pictures for the step by step process.
Thoroughly clean the area to be treated. The surface must be dry and free of dirt and grease. Shake the pen well for about 30 seconds, then remove the cap and vent the pen with the tip pointing upwards by pressing the felt tip. Then, turn the pen over and press down on the tip on a piece of paper (up to 20 times) until the clear lacquer flows into the felt tip.
Place the tip on the scratch and carefully guide it along the scratch. Remove excess clear lacquer around the damaged area immediately with a clean, dry paper towel.
For deeper damage and thicker layers, repeat the application after every 30 minutes of drying time. Replace the cap firmly after use to protect the pen from drying out.
After a drying time of at least 48 hours, the Quixx Paint Scratch Remover can be used to polish the repaired location smoother. (Sold Separately)
The Quixx Paint Repair Pen can quickly and easily seal stone chips, for example, on the hood. The special tip, similar to a felt tip marker, enables the amount of paint to be properly controlled and precisely applied.
It is best to pat the affected area several time and then allow the treated area to dry thoroughly. The smooth finish of the paint surface can then be restored by applying a good polishing agent (try the Quixx Paint Scratch Remover Kit).
Caution: In the case of older stone chips that may already have rust, the rust should be removed first.
No, the scratch is sealed with a clear varnish.
No, you will still see the scratch. However, it is closed, and the sheet metal is thus protected from corrosion. The damaged area will look better than before. If scratches are removable, you should use the Quixx Paint Scratch Remover Kit.
Yes, it works very well. The QUIXX PRP can also be used for the final treatment of damaged areas that have been repaired with the manufacturer’s touch-up pen. A combination with QUIXX PSR is also very possible.
Permanent. The clear coat remains on the damaged area after it has had time to cure for a few days.
You can easily remove any excess lacquer from your car by using common nail polish remover. However, this should be tested in an inconspicuous area for compatibility first. A clean, white cotton cloth is all you’ll need. Apply the polish remover to the cloth, not directly on the car.
Only logged in customers who have purchased this product may leave a review.